Fine Beautiful Socket On Lighting Circuit

It keeps blowing the fuse so he puts in a bigger one this causes the 1 5mm to overheat thus.

Socket on lighting circuit. With the move toward intelligent and automated homes there will be more and more locations with lighting sockets which are switched remotely either through a relay often rated for 1 or 2 a or a dimmer again anywhere from 250 to 500w. Sockets intended for general use with a current rating must be rcd protected. Shaver units may also be connected to the lighting circuit treat it as equivalent to one 100 watt lamp where installed in a bathroom or a room containing a shower the shaver unit must incorporate an isolating transformer.

Not considered good practice to fit a 13a socket to a lighting circuit. The provision of more an more low voltage lights leds or 12v halogen with plug in transformers goes totally against the drive for energy efficiency. The consumer unit is normally connected to the first lamp which in turn is connected to the second lamp and so on.

Yes but preferably 2 amp or 5 amp. You can t put a 13amp socket on a 6amp lighting circuit full stop even if you know what its for. The diversity guidenlines say you should allow at least half a sockets rating for a socket on a lighting cuircuit but it must be remembered that diversity guidelines are just that.

Shaver lights and sockets can be run directly from the lighting circuit if you are adding a false cieling with recessed lights then simply run an extra permanent live feed to the shaver light from this circuit. However there are a couple of things to bear in mind. You have to look at what would happen at worst you forget the socket in the loft and move the new owner see s a nice socket outlet in the loft which will do the immersion heater nicely.

Putting a 13a socket on a lighting circuit is not expicilty prohibited.